What to do when the petrol trim tabs do not start?
Gasoline trimmer - surprisingly usefulA tool with which you can cut out not only a miniature lawn in front of the house, but a whole lawn of considerable size. Unfortunately, there is nothing eternal in this world, and therefore you may encounter the fact that the petrol trim tabs do not start.
It often happens that users of this kindmachines are trying to "save", pouring into the tank is not fuel with a normal octane number, but something incomprehensible that almost a decade already stood in a plastic canister.
The main thing is a fuel mixture!
In this case, the residues dissolved in the aggressivethe environment of plastic creates such terrible things in the combustion chamber that you will not be able to do without a complete cleaning of the mechanism. But you certainly will remember forever how to store fuel properly.
What to do when the fuel was exactlynormal, there is a spark, but the petrol trimmer does not start? It's possible that you just filled the candle with gasoline. In this case, it must be turned out, wiped with a clean rag and dried. By the way, it will not be superfluous to check the candle itself for work capacity.
Correctly produce a cold start!
Often, petrol trim tabs do not start afterof how they are trying to "put into operation" after long-term storage. Failures with start-up in this case are often caused by incorrect actions of the user.
If you are confronted with this phenomenon, thenat a cold start it is necessary to close the damper, then to pump a small amount of the fuel mixture into the carburettor. Then pull out the starting handle to the sensation of resistance, after which, with sharp and vigorous movements, start the trimmer.
After several jerks, it will start and stall, which is normal. After moving the flap to the working position, start the tool again and start working.
There are not only situations where trimmersgasoline does not start, but the cases when after launch they work a couple of seconds and then stall. Re-examine the spark plug: if it is "thrown", and this situation is repeated even after it is wiped and dried, go to the "revision" of the air filter.
Most likely, it is completely oily and needs replacing. If the filter is OK, it may be that the ignition coil has failed.
In the event that the petrol trim tabs do not start, and you have done all of the above, a muffler can be clogged. It needs to be dismantled, burned on the burner, after which all the carbon can be easily shaken out.
And again the carburetor ...
Even if after such mockery yourthe trimmer will not start, you can not do without disassembling the carburetor. It may very well be that it is the fault of the needle misalignment in it. In any case, the disassembly and washing of this capricious mechanism certainly will not interfere.
In general, when the trimmer began to be capricious andit is advisable to carry out full prophylaxis: completely change the fuel mixture, try another oil, and also necessarily change the candle. Practice shows that in many cases it is the low-quality candles that are to blame.
We have considered the most typical reasons why,why not start a trimmer. If the case is something more "exotic", do not pass the hike to the service center. Smaller and more obvious breakdowns you will surely find for yourself.